Honeywell MILLER Vi-Go Serie Manual De Isntrucciones página 12

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5.5 Installation of Cable
and Tensioning Assembly
to Bottom Bracket Assembly
1. Install saddle clips loosely around cable attached
to tension rod (see Fig. 6).
2. Slide the tension rod down the cable and through
amount of threads are through to install the
compression spring, washer and tensioning nut.
3. Remove excess cable by pulling cable through the
saddle clips. Tighten and torque saddle clips to
40 to 45 ft. lbs.
4. Tighten tensioning nut until cable is taut.
achieved. Do not completely compress spring.
repeat procedure from Step 3.
5. When proper tensioning of cable is achieved,
install jam nut against tensioning nut.
6. Discard excess cable by cutting below the lower
5-1/2"
Tensioning Assembly and
required. Using a hand punch, designate the appropriate system capacity rating, installation date and service/
inspection dates using the spaces provided on the label. Attach the label to the ladder or structure with the nylon
tie provided. Attach the label to the system where it is easily accessible to anyone using the system. Record
Us er Instruct i o n s - E n g l i sh
Assembly with
Cable Installed
Saddle
Clip
Compression
Spring
12
Fig. 6
Tension
Tensioning
Rod
Washer
Nut
Jam Nut

Publicidad

Tabla de contenido
loading

Tabla de contenido