Setting The Oven Controls - Kenmore 790.4045 Manual De Uso

Setting Oven Controls
Note: The time of day must first be set in order to operate the oven.
To Set the Clock
When the range is first plugged in, or when the power supply to the range has been interrupted, the display will
flash "12:00".
1. Press once (do not hold pad down).
2. Within 5 seconds, press and hold the
Note: The clock cannot be changed during any timed bake or Self-Clean cycle.
To Set the Minute Timer:
1. Press .
2. Press the to increase the time in one minute increments. Press and hold the
minute increments. The timer can be set for any amount of time from 1 minute to 11 hours and 59 minutes.
Note: If the
pad is pressed first, the timer will advance to 11 hours and 59 minutes.
3. The display shows the timer countdown in minutes until 1 minute remains. Then the display will countdown in
seconds.
4. When the set time has run out, the timer will beep 3 times. it will then continue to beep 3 times every 60
seconds until
Note: The indicator light located above the
Note: The minute timer does not start or stop cooking. It serves as an extra timer in the kitchen that will beep
when the set time has run out. The minute timer can be used alone or during any of the other oven functions.
When the minute timer is in use with any other function, the minute timer will be shown in the display. To view
other functions, press the pad for that function.
To Change the Minute Timer while it is in use:
While the timer is active and shows in the display, press and hold the
To Cancel the Minute Timer before the set time has run out: Press
Note: To turn the time of day display OFF or ON in the display press
beep once) and then release. This feature does not remove the set time of day from the memory of the control. When
the display is turned OFF the time of day will re-appear for a few seconds any time the
or
is pressed.
until the correct time of day appears in the display.
pad will glow while the minute timer is active.
8
to increase the time in 10
or to increase or decrease the time.
.
and hold for 8 seconds (the control will
pad is touched.