Adjusting Network - Pioneer DEH-P9450MP Manual De Operación

2. Press the corresponding button to select
the speaker unit (filter) to be adjusted.
Button Speaker unit (filter)
L LPF Low-range speaker LPF
M HPF Middle-range speaker HPF
M LPF Middle-range speaker LPF
H HPF High-range speaker HPF
3. Press MUTE to mute the selected speaker
unit (filter).
"MUTE" blinks in the display.
• Press MUTE again to cancel the muting.

Adjusting network

1. Press AUDIO and then press NW to
select the network adjustment mode.
2. Press the corresponding button to select
the speaker unit (filter) to be adjusted.
Button Speaker unit (filter)
L LPF Low-range speaker LPF
M HPF Middle-range speaker HPF
M LPF Middle-range speaker LPF
H HPF High-range speaker HPF
3. Press 2 2 or 3 3 to select the cut-off fre-
quency (crossover frequency) of the
selected speaker unit (filter).
L LPF: 31.5 Ô 40 Ô 50 Ô 63 Ô 80
Ô 100 Ô 125 Ô 160 Ô 200 (Hz)
M HPF: 31.5 Ô 40 Ô 50 Ô 63 Ô 80
Ô 100 Ô 125 Ô 160 Ô 200 (Hz)
M LPF: 1.6 Ô 2 Ô 2.5 Ô 3.15 Ô 4
Ô 5 Ô 6.3 Ô 8 Ô 10 Ô 12.5
Ô 16 (kHz)
H HPF: 1.6 Ô 2 Ô 2.5 Ô 3.15 Ô 4
Ô 5 Ô 6.3 Ô 8 Ô 10 Ô 12.5
Ô 16 (kHz)
4. Press 5 5 or ∞ ∞ to adjust the level of the
selected speaker unit (filter).
Each press of 5 or ∞ increases or decreas-
es the level of the selected speaker unit (fil-
ter).
• "0dB" — "–24dB" is displayed as the level
is increased or decreased.
• "+6dB" — "–24dB" is displayed as the level
is increased or decreased, only if you have
selected "L LPF".
5. Press SLOPE to select the slope of the
selected speaker unit (filter).
L LPF: –12 = –18 = –6 (dB/oct.)
M HPF: –12 = –18 = Pass (0) =
–6 (dB/oct.)
M LPF: –12 = Pass (0) = –6 (dB/oct.)
H HPF: –12 = –6 (dB/oct.)
6. Press PHASE to switch the phase of the
selected speaker unit (filter).
Each press of PHASE switches the phase
between normal
• You can adjust the parameters for other
speaker units (filters) in the same way.
7. Press BAND to cancel the network
adjustment mode.
and reverse .
36