First Use - Zanussi ZBF22450SA Manual De Instrucciones

Functions Menu
Each time Function button is pressed, the fol-
lowing functions are activated in a clockwise di-
rection:
• Fast Freeze function
• no symbol: normal operation.
Switching off
The appliance is shut off by pressing ON/OFF
switch for more than 1 second.
After this, a countdown of the temperature from
-3 -2 -1 will be shown.
When the appliance is switched off, Display al-
so goes off.
Temperature regulation
The temperature within the appliance is control-
led by the Temperature regulator situated at the
top of the cabinet.
To operate the appliance, proceed as follows:
• turn the knob clockwise to obtain the maxi-
mum coldness
• turn the knob counter- clockwise to obtain
the minimum coldness.
The intermediate position is usually the most
suitable.
However, the exact setting should be chosen
keeping in mind that the temperature inside the
appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Fast Freeze Function
To freeze fresh foods, you will need to activate
the Fast Freeze function.
Press Function button (several times if neces-
sary) until the corresponding icon appears.

First use

Cleaning the interior
Before using the appliance for the first time,
wash the interior and all internal accessories
with lukewarm water and some neutral soap so
www.zanussi.com
This function stops automatically after 52
hours.
It is possible to deactivate the function at any
time by pressing Function button (refer to
"Functions Menu").
Excessive temperature alarm
An increase in the temperature in the freezer
compartment (for example due to a power fail-
ure) is indicated by:
• flashing temperature
• red illumination of display
• sounding of buzzer
When normal conditions are restored:
• the acoustic signal shuts off
• the temperature value continues to flash
• the display illumination remains red.
When you press Function button to deactivate
the alarm, the highest temperature reached in
the compartment appears on indicator
some seconds.
At this point the flashing stops and the display
illumination changes over from red to white.
Door open alarm
An acoustic alarm will sound when the door is
left open for more than 1 minute.
The door open alarm conditions are indicated
by:
• flashing Door open alarm indicator
• red display illumination
• beeping sound.
Press the Function button to deactivate the
acoustic alarm.
When normal conditions are restored (door
closed), the acoustic alarm will stop.
as to remove the typical smell of a brand-new
product, then dry thoroughly.
Important! Do not use detergents or abrasive
powders, as these will damage the finish.
for
27