Getting Started - Ribimex Ribitech PRDATR151 Manual De Uso Y Mantenimiento

Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other
conditions that may affect its operation.
15. Warning
The use of any accessory or attachment, other than those recommended in this instruction manual, may present
a risk of injury to persons or animals and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or persons.
16. Have your tool repaired by a qualified person
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part in an
authorized service center is recommended.
Repairs should only be carried out by qualified persons using original spare parts, otherwise this may result in
considerable danger to the user.
17. Remarks:
The safety precautions and instructions given in this manual are unable to cover in detail all the conditions and
situations that may arise.
The operator and/or user must use common sense and caution when operating the product especially for any
matters that are not referred in the above
SAFETY INSTRUCTIONS SPECIFIC TO THE PRODUCT
(a) Do not open / modify the hose reel. Never open the hose reel and never modify it.
(b) Check pressure resistance. Compare the information on the rating plate with those mentioned on the
compressor.
(c) Ensure that the maximum available air pressure is not higher than the one indicated on the rating
plate. Bursting hazard of the hose or damaged to the fittings in case of non-compliance with specified values.
(d) Stop using if damaged. Stop using the air hose reel in case of malfunctions and defects / damage. Impacts
or cuts to the hose can cause damage.
(e) Protect the air hose. Protect the air hose against chemicals avoiding contact with products such as oil,
acids, corrosives liquids; ...
Protect the air hose against mechanical risks such as pinching, crushing, jamming, torsion solicitations;
impacts; sharp edges and/or sharp points; situations where the hose might be tread upon or rolled over ...
Protect the air hose against risk of direct exposure to sun light; very hot temperatures; very low temperatures; ...
Product may get damaged in case of non-compliance with these instructions.
IV. GETTING STARTED
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage
4.2- Installation
This reel is best installed close to a source of air.
However, for a large area, please place it in the center of the work area and then you can extend the hose to the
most convenient point in this area.
4.2.1- Wall-mount installation
The mounting bracket can be installed to a brick wall.
There are many alternative positions in which the unit can be placed.
The key point is subject to what is convenient for the user.
The most appropriate position is to mount it on a wall or post, approximately 80cm (0.8m) above the ground.