Rds Broadcasts; Timer; Setting The Clock; Play Timer - Panasonic SC-HC4 Instrucciones De Funcionamiento

RDS broadcasts

For Continental Europe
Enable you to display the name of a broadcasting station or a program
type.
"RDS" lights while RDS signals are being received.
Press [DISPLAY] to display.
Station Name (PS)
Frequency display
Note
RDS displays may not be available if reception is poor.
Program type displays
NEWS VARIED
AFFAIRS POP M
INFO ROCK M
SPORT M-O-R- M*
EDUCATE LIGHT M
DRAMA CLASSICS
CULTURE OTHER M
SCIENCE WEATHER
* M-O-R- M = Middle-of-the-Road music
10
10
Program Type (PTY)
FINANCE COUNTRY
CHILDREN NATIONAL
SOCIAL A OLDIES
RELIGION FOLK M
PHONE IN DOCUMENT
TRAVEL TEST
LEISURE ALARM
JAZZ

Timer

Setting the clock

This is a 24-hour clock.
 Press [CLOCK/TIMER] to set the clock.
 Press [u/t] or [y/i] to select the time within 5 seconds.
(Press and hold to change the time faster.)
 Press [CLOCK/TIMER] again.
g To display the clock for few
seconds when the unit is on or in
standby mode
Note
Reset the clock regularly to maintain accuracy.

Play timer

You can set the timer to come on at a certain time to wake you up.
This unit offers 3 optional play timers.
Preparation:
• Turn the unit on and set the clock. (➡ see above)
• Prepare the music source (disc, radio, iPod, AUX or USB) and set
the volume.
 Press [CLOCK/TIMER] repeatedly to select play timer.
CLOCK
zPLAY 1
Original display
 Within 5 seconds, press [u/t] or [y/i] to set the starting
time.
Start time
Play timer indicator
 Press [CLOCK/TIMER] to confirm.
 Repeat steps 2 and 3 to set the finishing time.
Finish time
To activate the timer
 Press [z, PLAY] repeatedly to turn on your desired play timer.
 Press [^] to turn off the unit.
To Action
change the settings Repeat steps 1 to 4 and 6.
change the source or
 Press [z, PLAY] to clear zPLAY
volume
indicator from the display.
 Make changes to the source or volume.
 Perform steps 5 and 6.
check the settings Press [CLOCK/TIMER] repeatedly to
(when the unit is on or select zPLAY 1, zPLAY 2 or zPLAY 3.
in standby mode)
cancel
Press [z, PLAY] to clear the timer
indicator from the display.
Note
• The timer will start at the preset time, with the volume increasing
gradually to the preset level.
• The timer comes on at the set time every day if the timer is on.
• The unit must be in the standby mode for the timer to function.
• If you turn the unit off and on again while the timer is functioning, the
finish time setting will not be activated.
• When external unit is selected as the source when the timer comes
on, the system turns on and engages external unit as the source. If
you wish to playback from the portable audio equipment, activate the
equipment's play mode and increase the volume. (See the portable
audio equipment's instruction manual.)
Press [CLOCK/TIMER]
zPLAY 2 zPLAY 3