Stroke Speed Control; Dust Extraction; Working With The Electric Power Tool; Free Guidance Along A Scribe Mark - Festool Trion PS 300 EQ Manual De Instrucciones

English
Recommended pendulum stroke setting
Hardwood, softwood, chipboard, wood
fibreboard
Blockboard, plywood, plastic
Ceramics
Aluminium, non-ferrous metals
Steel
8.7

Stroke speed control

The stroke rate can be continuously adjusted
between 1000 and 2900 min
ing wheel [10-1; 10-2]. This enables you to opti­
mise the cutting speed to suit the respective
material.
10.1
PS 300 EQ
Recommended stroke speed (position of the
adjusting wheel)
Hard and soft wood, blockboard, ply­
wood, chipboard
Fibreboard
Plastic
Ceramic, aluminium, non-ferrous
metals
Steel
8.8

Dust extraction

WARNING
Heath hazard posed by dust
► Always work with an extractor.
► Only use a dust extractor designed to col­
lect the specific type of dust and particles
from the material being cut.
► Follow OSHA and NFPA regulations to en­
sure a safe work environment.
The extraction adapter [11-4] allows jigsaws to
be connected to a dust extractor (hose diameter
27 mm).
12
1 - 3
1 - 2
0
0 - 2
0 - 1
-1 using the adjust­
10.2
PSB 300 EQ
6
4 - 6
3 - 6
3 - 5
2 - 4
Always use a splinterguard when working
with extraction to prevent the extraction
channels from becoming blocked.
► Insert the extraction adapter in the rear
opening of the saw table so that the
hook [11-2] engages in the recess [11-1].
► To remove the extraction adapter, press the
lever [11-3].
11-1
9 Working with the electric
power tool
WARNING
Risk of injury
► Always secure the workpiece in such a
manner that it cannot move while being
machined.
9.1

Free guidance along a scribe mark

The triangular shape of the splinter­
guard [12-1] indicates the cutting line of the
saw blade. This facilitates sawing along a scribe
mark.
12-1
9.2

Plunging without pre-drilling

In order to produce plunge cuts in wood work­
pieces, the saw table must be in the forward
position (base position, see fig. [1]).
► Position the saw onto the workpiece with
the front edge of the saw table
► and plunge the saw into the workpiece at
the maximum stroke rate and in pendulum
stroke setting 3, see fig. [13].
11-2 11-3 11-4
11
12