Nuna Stokke PIPA Manual Del Usuario página 36

Only install in The locking clip should be 1/2 inch (12.5mm)
from the buckle.
1/2 in.
(12.5 mm)
Installation in an Aircraft
• Position carrier so that child is facing the aircraft
seat.
• Route the aircraft lap belt under both lap belt
guides and buckle.
• Adjust the angle of the carrier. A rolled up
towel or foam pool noodle may be used to
help adjust the amount of recline. (Page 34)
The angle is correct when the blue line is level
with the floor of the aircraft.
• Tighten the aircraft belt while pushing the carrier firmly into the seat.
• When installing in an airplane using a base, follow the instructions for vehicle installation
with a base using lapbelt only. (Pages 28-30)
This Child Restraint is certified for use in commercial aircraft with or without the base. Be
sure to contact your airline prior to travel to discuss their Child Restraint policy.
EN
36 Stokke® PIPA™ by Nuna®