Power Button; Add A Garment - Kenmore 110.2810 Serie Manual De Uso Y Cuidado

POWER BUTTON

7
Press to turn the washer ON. Pressing once while the washer
is on will cancel the current cycle.
CYCLE STATUS LIGHTS INDICATOR
8
The Cycle Status Lights show the
progress of a cycle� At each stage of
the process, you may notice sounds
or pauses that are different from
traditional washers.

ADD A GARMENT

You may place additional clothing
in the wash when the Add a
Garment indicator is lit without
sacrificing wash performance.
Press START/PAUSE once. The Lid
Lock light will turn off. Open the
washer lid, add garments, and
close the lid. Press START/PAUSE
to restart�
PREWASH/SOAK
When the Prewash option is selected, this light will come
on to indicate that the Prewash process is occurring. If the
Soak cycle is selected, the light will be lit for the duration
of the cycle�
WASH
You will hear the motor and washplate moving the load.
It is normal for some of the load to be above the water
line. Low-water cleaning means concentrated cleaning.
Rather than diluting detergent as done in an agitator-style
washer, this washer delivers the detergent directly to the
soils. The motor sounds may change at different stages
in the cycle. The wash time is determined by the selected
Soil Level�
6
RINSE
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load. You may hear the
motor turning on briefly to move the basket while filling.
Fabric softener will be added if the Fabric Softener option
was selected. Some cycles use spray rinsing.
SPIN
The washer spins the load at increasing speeds for proper
water removal, based on the selected cycle and spin
speed�
CYCLE COMPLETE
Once the cycle is complete, this light will come on.
Remove the load promptly for best results�
LID LOCKED
To allow for proper load sensing and spinning, the lid
will lock and the Lid Locked light will turn on. This light
indicates that the lid is locked and cannot be opened�
If you need to open the lid, press START/Pause/UNLOCK
LID. The lid will unlock once the washer movement has
stopped. This may take several minutes if the load was
spinning at high speed. Press START/PAUSE/UNLOCK LID
again to resume the cycle�
To turn Button Sounds either On or Off:
While washer is off (before pressing Power button), press the
following buttons within 5 seconds: Wash Temp - Cycle Signal
- Wash Temp - Cycle Signal. Washer will make a single beep
when the process is complete.
NOTE:
• Cycle Signal Button will still operate, even if you turned
the button sounds off.
• Whatever your preferences are, they remain in effect
through a power loss.
• The Default setting for button sounds is ON�