Maytag WT-TOD Guía De Usuario página 12

Ocultar thumbs Ver también para WT-TOD:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance
Removal of Gas
Appliance
Gas appliance connectors used to connect
this appliance to the gas supply are not
designed for continuous movement. Once
installed, DO NOT repeatedly move this
gas appliance for cleaning or to relocate. If
this appliance has to be moved and/or
removed for servicing, follow the proce-
dure described in the installation instruc-
tions.
To prevent range from accidentally tip-
ping, range must be secured to the floor by
sliding rear leveling leg into the anti-tip
bracket.
Oven Window
(select models)
To protect the oven door
window:
1. Do not use abrasive cleaning agents
such as steel wool scouring pads or
powdered cleansers as they may scratch
the glass.
2. Do not hit the glass with pots, pans,
furniture, toys, or other objects.
3. Do not close the oven door until the
oven racks are in place.
Scratching, hitting, jarring or stressing the
glass may weaken its structure causing an
increased risk of breakage at a later date.
11
, cont.
Oven Light
(select models)
CAUTIONS:
• Disconnect power to range before
replacing light bulb.
• Use a dry potholder to prevent pos-
sible harm to hands when replacing
bulb.
• Be sure bulb is cool before touching.
• Do not touch hot bulb with a damp
cloth as this may cause the bulb to
break.
To replace light bulb:
1. Remove light bulb.
2 Replace with a 40 watt appliance bulb.
3. Reconnect power to range. Reset clock.
Lower Panel
(select models)
Ranges that do not feature a lower broiling
compartment will have a panel in place of
the broiler door.
To remove panel:
Grasp the bottom corners of the panel.
Then lift the panel up and away from the
range.
To replace panel:
Align the four slots on the panel with the
four screws on the range front frame. Then
lower the panel and push down until the
panel snaps into place.
Conventional
Surface Burners
(select models)
Under no circumstances are the surface
burner assemblies to be taken apart for
cleaning. The surface burner assembly can
be removed to clean the burner box area.
Freestanding range only:
The two surface burner assemblies are
secured in place during transportation with
screws. Once the range is installed, these
screws may be removed to allow quick
and easy removal of the burner assem-
blies.
To remove: Allow the burner assembly to
cool. Lift up cooktop. Grasp the burner
assembly and rotate it slightly toward the
left to release the two tabs on the assembly.
Then lift the assembly and pull toward the
back of the cooktop until the air shutter
ends on the assembly release from the
valves.
To replace: Insert the air shutter ends on
the burner assembly over the valves and
lower the assembly into place. Be sure to
secure the two tabs on the burner assem-
bly into the two slots on the burner sup-
port bracket which is mounted to the
burner bottom. (NOTE: If the tabs are not
properly inserted into the slots, the assem-
bly may rock and the burners may not
light properly.)

Publicidad

Tabla de contenido
loading

Tabla de contenido