Electrical Connection - Magic Chef MCSRE24S Manual Del Usuario

Install the anti-tip bracket to hold the left rear leg of the slide-in range. Follow these steps to secure the range to
the floor before moving the range into final operating position.
1. before moving range, slide range onto shipping base
cardboard or hardboard.
2. It is recommended to create a template out of paper
to help with installation. Place this template on floor
in the cabinet opening so that the left edge is against
cabinet and top edge is against rear wall, molding or
cabinet. (Refer to Figure 5.)
3. Tape template in place.
4. If countertop is deeper than 25" (635 mm), measure
and mark a distance of 25" (635 mm) in from front of
countertop and align template with mark. (Refer to
Figure 6.)
5. If countertop is not flush with cabinet opening edge,
align template with overhang.
6. If cabinet opening is wider than specified in
Installation Instructions, adjust template so range will
be centered in cabinet opening.
7. To mount anti-tip bracket to wood floor, drill two
1/8" (3.2 mm) holes at the positions marked on the
bracket template. (Refer to Figure 7.)
8. Remove template from floor.
9. Tap plastic anchors into holes with a hammer.
10. Align anti-tip bracket holes with holes in floor. Fasten anti-tip bracket with
screws provided. (Refer to Figure 8.)
11. Move range close to opening. Remove shipping base, cardboard or hardboard
from under range. Connect power supply cord as described in the "Electrical
Connection" section on page 13. Move range into final position, making sure rear
leveling leg slides into anti-tip bracket. (Refer to Figure 9.)
12. Continue installing your range following the installation Instructions.

ElECTRICAl CONNECTION

WARNING: Electrical Shock Hazard
• DO NOT use an adapter.
• DO NOT use an extension cord.
• Failure to follow these instructions can result in death, fire, or electrical shock.
• Electrical connection must be performed by a qualified service technician in accordance with the kit
instructions and all local codes and requirements.
This appliance is not supplied with a plug and needs to be connected directly to the electrical mains.
If you wish to install this appliance with a plug, it must installed by a qualified technician. The plug must be a
4-prong, 3-phase power plug that is designed specifically for ranges and ovens.
Figure 5
25.0"
(635 mm)
Template
Figure 7
13
Figure 6
25.0"
(635 mm)
Template
Figure 8
Figure 9