Returning For Service - DeFelsko PosiTector DPM Guía Rápida

Before returning the instrument for service...
1.Install new batteries in the proper alignment as shown within
battery compartment.
2.Examine the surface temperature sensor for dirt or damage.
3.Perform a Hard Reset (see pg. 3)
If you must return the Gage for service, describe the problem fully
and include measurement results, if any. Be sure to also include
the probe, your company name, company contact, telephone
number and fax number or email address.
Website: www.defelsko.com/support
Limited Warranty, Sole Remedy
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted, in whole
or part, by any means, without written permission from DeFelsko Corporation.
DeFelsko and PosiTector are trademarks of DeFelsko Corporation registered in the U.S. and in other
countries. Other brand or product names are trademarks or registered trademarks of their respective
holders.
Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not
responsible for printing or clerical errors.

Returning for Service

Returning for Service
and Limited Liability
and Limited Liability
www.defelsko.com
© DeFelsko Corporation USA 2012
All Rights Reserved
9