Quick Start - DeFelsko PosiTector DPM Guía Rápida

The PosiTector DPM powers-up when the center navigation
button is pressed. Readings are updated automatically each
second. To preserve battery life, the instrument powers down after
approximately 5 minutes of no activity. All settings are retained.
1. Remove the protective rubber cap from the surface
temperature sensor.
2. Power-up Gage by pressing the center navigation
A typical instrument screen is shown below, consisting of RH, Ta,
Ts, Td, and Ts-Td readings. This group of readings is referred to as
a dataset.
Button Functions- Normal Operation
Scroll through
Trend Charts
(Advanced only)
Access the Menu
Introduction
Introduction

Quick Start

Quick Start
RH
- Relative Humidity (measured)
Ta
- Air Temperature (measured)
Ts
- Surface Temperature (measured)
Td
- Dew Point (calculated)
Ts-Td
- Surface minus Dew Point
Temperature (calculated)
Tw
- Wet Bulb Temperature (calculated)
(Advanced Models Only)
1
button.
Pause / Resume
Restore brightness
after dimming
(Advanced only)