Returning For Service - DeFelsko PosiTector 200 Guía Rápida

Before returning the Gage for service...
1. Install new or newly recharged batteries in the proper
alignment as shown within battery compartment.
2. Examine the probe tip for dirt or damage.
3. Perform a Hard Reset (pg. 7) and a Zero (pg. 5).
4. Place a plastic shim onto a hard surface (i.e. glass)
and attempt a measurement. (pg. 3)
5. If issue is not resolved, Update your PosiTector gage body
(pg. 12) and re-attempt measurements.
If you must return the Gage for service, describe the problem
fully and include measurement results, if any. Be sure to also
include the probe, your company name, company contact,
telephone number and fax number or email address.
Website: www.defelsko.com/support
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted, in whole or
part, by any means, without written permission from DeFelsko Corporation.
DeFelsko and PosiTector are trademarks of DeFelsko Corporation registered in the U.S. and in other coun-
tries. Other brand or product names are trademarks or registered trademarks of their respective holders.
Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not
responsible for printing or clerical errors.

Returning for Service

and Limited Liability
www.defelsko.com
© DeFelsko Corporation USA 2016
All Rights Reserved
13