Surtek SM710 Manual De Usuario página 35

To change the Blade Depth
The blade depth should be set so that the out-
er tips of the blade are higher than the work-
piece by approximately
1/8 in. to 1/4 in. but the lowest points (gullets)
are below the top surface. Raise the blade by
turning the blade adjusting handle counter-
clockwise or lower it by turning the handle
clockwise.
Gullet
To change bevel angle
A 90° cut has a 0° bevel and a 45° cut has a
45° bevel.
• Unplug the saw.
• Loosen bevel control by turning bevel lock
lever all the way to the left. If it needs to be
further loosened, pull spring-loaded bevel lock
lever out and rotate it back to the right. Re-
lease bevel locking lever and allow it to seat
(lock) in its original position. Turn it to the left
again until loose.
• Adjust the bevel angle by sliding the blade
adjusting handle left or right to the desired
angle.
• Tighten bevel control by turning bevel lock
lever to the right. If it needs to be tightened
more, pull the spring-loaded bevel lock lever
out and rotate it to the left. Then release bevel
lock lever and allow it to return to its original
position. Rotate to the right again. Repeat this
process until bevel lock lever is securely tight-
ened.
NOTE: Prior to making cuts, the bevel lock lever
must be in the locked position.
E N G L I S H •
To adjust the bevel indicator
If the bevel indicator is not at zero when the
saw blade is at 90°, adjust the indicator by
loosening the screw and setting it at 0° on the
bevel scale. Retighten the screw.
To Lock
WARNING: To reduce the risk of injury, al-
ways make sure the rip fence is parallel to the
blade before beginning any operation.
To install the rip fence
• Place the rear lip on the rear of the saw table
and pull slightly toward the front of the unit.
• Lower the front end of the rip fence onto the
guide surfaces on top of the front rail.
• Push the rip fence lever down to automati-
cally align and secure the fence. The trigger
lock must engage.
Check for a smooth gliding action.
Rip Fence
Rip Fence
lever
Rear Lip
Saw Table
U se r' s m a nu a l
To Unlock
Screw Driver
Bevel Indicator Screw
35