Installing The Ribbon - Epson TM-U230 Manual De Usuario

English
3. Insert the roll paper; then hold both edges of the paper and insert it
straight into the paper insert slot until the paper is fed automatically, as
shown in illustration F.
Note:
Note the direction the paper comes off the roll, as shown in Illustration G.
4. When the paper feeding is finished, tear off the fed paper with the manual
cutter.
5. Close the roll paper cover.
6. When the PAPER OUT LED flashes, press the FEED button to set the
printer online.
Note on the PAPER OUT LED
When the paper has reached the end or near end, the PAPER OUT LED comes
on. The buzzer will also sound if the printer has been set for the buzzer to
sound for the end or near end of the paper. Opening the cover to replace paper
or pressing the FEED button stops the buzzer sound.

Installing the Ribbon

CAUTION:
Be sure not to touch the manual cutter. Otherwise your fingers might be
injured.
Use the EPSON ERC-38. The use of any ribbon cassettes other than those
approved by Epson may damage the printer and will void the warranty.
1. Turn on the printer. Turn the knob on the ribbon cassette, as shown in
illustration H.
2. Open the roll paper cover and cutter cover.
3. Lift the autocutter, using the tab, as shown in illustration I; then insert the
new ribbon, as shown in illustration J.
4. Turn the knob 2 or 3 times again and check if the ribbon cassette is in the
right position.
Troubleshooting
ERROR LED on or flashing.
❏
Check to see that the roll paper and cutter covers are closed, and check the
PAPER OUT LED. Replace the paper when necessary.
❏
If the paper is jammed, remove the jammed paper, following the paper
jam description below.
❏
Turn off the printer for a few seconds and then turn it back on. If the LED
is still flashing, call your supervisor or a service person.
6 TM-U230 User's Manual