Sound Effects; Clock And Timers - Panasonic SC-HC27 Instrucciones De Funcionamiento

Improving the sound quality
1
Press [PLAY MENU] to select "FM MODE".
2
Press [R, T] to select "MONO" and then press [OK].
To cancel, select "STEREO".
"MONO" is also cancelled when you change the
frequency.
To memorise the setting
Continue with steps 4 through 6 of "Manual tuning and
presetting".
Checking the signal status
Press [PLAY MENU] to select "FM STATUS" and then
press [OK].
FM The FM signal is in monaural.
The system is not tuned in to a station.
FM ST The FM signal is in stereo.
FM MONO "MONO" is selected as the "FM MODE".
RDS broadcasting
This system can show the text data transmitted by the radio
data system (RDS) available in some areas.
Press [DISPLAY].
PS Station name
PTY Program type
FREQ Frequency
Note:
RDS may not be available if reception is poor.

Sound effects

1
Press [SOUND] to select a sound effect.
2
Press [R, T] to select the desired setting.
PRESET EQ "HEAVY" : Adds punch to rock.
"SOFT" : For background music.
"CLEAR" : Clarifies higher frequencies.
"VOCAL" : Adds gloss to vocal.
"FLAT"
BASS "BASS -4" to "BASS +4".
TREBLE "TREBLE-4" to "TREBLE+4".
D.BASS "ON D.BASS" or "OFF D.BASS".
SURROUND "ON SURROUND" or "OFF SURROUND".
8
8
: Cancels the sound effect.

Clock and timers

Setting the clock
This is a 24-hour clock.
1
Press [SETUP] to select "CLOCK".
2
Press [R, T] to set the time.
3
Press [OK].
To show the clock for a few seconds
Press [SETUP] to select "CLOCK" and then press [OK].
Note:
Reset the clock regularly to maintain accuracy.
Play timer
You can set the timer to come on at a certain time to wake
you up.
Preparation
Set the clock.
1
Press [SETUP] to select "TIMER ADJ".
2
Press [R, T] to set the start time.
3
Press [OK].
4
Do steps 2 and 3 again to set the end time.
To start the timer
1
Prepare the audio source you want to listen to and
set the volume.
2
Press [SETUP] to select "TIMER SET".
3
Press [R, T] to select "SET" and then press [OK].
"#" is shown.
The system must be switched off for the timer to
operate.
Check the 1. Press [SETUP] to select "TIMER ADJ".
settings 2. Press [OK].
Cancel 1. Press [SETUP] to select "TIMER SET".
2. Press [R, T] to select "OFF" and then
press [OK].
Note:
• The timer starts at a low volume and increases gradually
to the preset level.
• The timer comes on at the set time every day if the timer
is on.
• If you switch off the system and switch on again while a
timer is in operation, the timer will not stop at the end time.