Getting started
1
Connect the FM indoor antenna.
Place the antenna where reception is best.
2
Connect the AC mains lead.
Power consumption in standby mode: 0.2 W
(approximate)
Do not use an AC mains lead from other equipment.
To household mains socket
Note:
• Some settings return to default when you disconnect the
system.
• These speakers do not have magnetic shielding. Do
not put them near TVs, PCs or other equipment easily
influenced by magnetism.
• You cannot remove the net of the speakers.
Preparing the remote control
Before using
Replacing the battery
Replace with a new battery (CR2025 lithium battery).
1
While pressing the stopper, pull out the battery
holder.
2
Insert a new battery with the (+) side facing up.
3
Push the battery holder back fully.
Tape
Insulation sheet
CR2025
iPod/iPhone, Disc, USB
Inserting or removing media
iPod/iPhone
Push [iPod x] to open the dock tray.
Connector
Note:
• Make sure to remove the iPod/iPhone from its case.
• Make sure to align your iPod/iPhone with the connector
when inserting.
• Use a compatible dock adapter.
• If a dock adapter is not available, insert and remove the
iPod/iPhone with care.
Disc
Press [CD x OPEN/CLOSE] on the main unit to open the
sliding door.
Put in a disc with the label facing towards you.
Click!
Note:
Keep fingers away from the sliding door when it is closing.
USB
Note:
Do not use a USB extension cable. The system cannot
recognise USB device connected through a cable.
iPod/iPhone
(not supplied)
Dock adapter
(not supplied)
USB device
(not supplied)
5
5