Filling The Water Tank; The First Time; Dry Ironing - Fagor PLV-125 Manual De Instrucciones

replacing, contact only a Technical
Support Centre authorised by the
manufacturer.
• Prevent the cable from touching hot
parts of the appliance.
• Use of this appliance produces high
temperatures. There therefore exists
a danger of burns when handling it.
For this reason, you must take hold of
the appliance by the handle and avoid
coming into contact with the metal
parts and with the steam.
• Do not direct the jet of steam at people
or animals because it is dangerous to
do so.
• Do not use the iron on very damp
fabrics.
• Do not leave the iron resting on its base
while it is still hot. You should wait until
it cools down.
• Do not mix together stain-removers or
similar products on fabrics which need
ironing.
• Unplug the appliance when it is not
being used. Only leave it plugged in
when necessary.
• Travel irons are not for everyday use.
• When you decide to get rid of the
appliance once and for all, you are
advised to unplug it and prevent it
from being used again by, for example,
cutting the power cable.
4. BEFORE USING THE IRON FOR

THE FIRST TIME

Remove the stickers or protective covering
from the soleplate and casing
Unroll and straighten out the mains cable.
Follow the instructions in the "Self-
cleaning" section of part "9 CLEANING
AND MAINTENANCE" to make the iron
ready for use.
INSTRUCTIONS FOR USE

5. DRY IRONING

1. Place the iron on a stable, heat-
resistant surface
2. Put the temperature control (8) in the
MIN position (Fig. B)
3. Ensure that the steam regulator (4) is in
the dry ironing position (fig. C)
4. Stand the iron in the upright position,
resting it on its stand (10) and plug it in.
5. Select the ironing temperature using
the temperature control (8). The LED
indicator (9) will light up.
6. When the LED indicator (9) switches
off, the iron has reached the selected
temperature.
This LED indicator will light up and
switch off during ironing indicating the
thermostat's cycles. Bear in mind that
if you lower the temperature, the LED
light (9) will remain off until the soleplate
(13) has come down to the selected
temperature and, at that moment, it will
light up again.
7. Press the spray button (5) to dampen
the garment as this makes dry ironing
easier. See section eight, sprayer.
8. When you have finished, turn the
temperature selector to the MIN
position and unplug the iron. Let it cool
down before proceeding to clean it on
the outside and put it away.
Warning: For dry ironing, make sure that
the steam regulator is always in the dry
ironing position. (Fig. C)

6. FILLING THE WATER TANK

Put the unplugged iron on a stable
surface.
1. Move the steam regulator (4) to the "0"
position.
2. Slowly pour the water through the opening
for water (3) with the help of a glass (Fig.
D). Do not pour any cleaning product or
solvent into the water tank (12).
3. Check that the water does not go
beyond the maximum filling level.
4. After ironing, empty the water tank (12).
Note: If the water in your area is too
hard ( >27ºF ) we recommend using
distilled water. Do not use battery water or
water containing additives such as starch,
perfume, fabric conditioner, etc.
10