Useful Information - Atlas Copco Pro S2480 Manual De Instrucciones

Safety and operating instructions
Handling
Tightening torque
The torque obtained depends on air pressure and
tightening time on the actual joint. Extensions and
worn bits will reduce the delivered torque. The im-
pact wrench should be used within the specified
torque range. Never use the machine over recommen-
ded maximum torque. Might result in improper
function and faster wear.
Test methods
A static torque measurement is recommended for
impact wrenches.
For test on hydraulic tension tester and for test on
joints.
Maintenance
Service instructions
Overhaul and preventive maintenance is recommen-
ded at regular intervals once per year or after maxim-
um 250.000 tightenings depending on which occurs
sooner. More frequent overhaul may be needed if
the machine is used in heavy-duty operations. If the
machine not is working properly, it should immedi-
ately be taken away for inspection.
The strainer at the air inlet and the exhaust silencer
should be cleaned frequently or replaced in order to
prevent clogging, which decreases the capacity.
At the overhauls, all parts should be cleaned accur-
ately and defective or worn parts (i.e. O-rings, vanes)
should be replaced.
It is important that the machines threaded connec-
tions are tightened properly; i.e. in accordance with
the specifications on the exploded views. Before as-
sembly, lubricate the threads with grease.
A
All o-rings should be greased before assem-
bling.
Impact mechanism
For best function and longest lifetime, additional
grease must be applied to the impact mechanism
between the overhauls.
The impact mechanism must not be packed with
grease; otherwise the function can be jeopardised.
Grease of type Almagard 3751 or 3752 from Lubric-
ation Engineers gives longer intervals between the
lubrications.
4
Grease guide
Brand
BP
Castrol
Esso
Q8
Mobil
Shell
Texaco
Molycote
Lubrication
Engineers
Rust protection and internal cleaning
Water in the compressed air, dust and wear particles
cause rust and sticking of vanes, valves etc. An air
filter should be installed close to the machine (see
'Air quality'). Before longer standstills, flush with
oil (some drops) into the air inlet, run the machine
for 5-10 seconds when absorbing the oil in a cloth.

Useful information

You can find all kind of information concerning Pro
products, accessories, spare parts, published matters
on our WEB site!
C Log in to www.pro-powertools.com
Technical data
Noise and vibration emission
Noise (according to ISO 15744)
Measured sound pressure level
Determined sound power level
Spread in method and production
Vibration (according to ISO 8662)
Measured vibration value
Spread in method and production
Declaration of noise and vibration emis-
sion
These declared values were obtained by laboratory
type testing in compliance with the stated standards
and are not adequate for use in risk assessments.
Values measured in individual work places may be
higher than the declared values. The actual exposure
Atlas Copco Tools - 9836 3988 00
General pur- Impact
pose mechanism
Bearings
Energrease LS-
EP2
Spheerol EP L2
Beacon EP2
Rembrandt EP2
Mobilegrease
XHP 222
Alvania EP2
Multifak EP2
Almagard
3751 / 3752
S2480
Air lubrica-
tion
Energol E46
Arox EP46
Chpin 46
Almo oil 525
Tonna R32
Aries 32
dB(A)
78 (tem-
porary)
-
3
2
m/s
<2.5 (tem-
porary)
-