Pioneer VSX-S520D Manual De Instrucciones página 50

> Before Start > Part Names
TV "AUDIO 1" to "AUDIO 2": Assign a desired AUDIO IN jack to the
TV input selector. (Default Value is "-----")
Speaker
You can make changes to the connection environment of the speakers and change the
volume level. Settings are automatically configured if you use Full Auto MCACC. This setting
cannot be selected if headphones are connected or audio is output from the speakers of the
TV because "Hardware" - "HDMI" - "Audio TV Out" is set to "On".
∫ Configuration
Speaker Channels Select from "2.1 ch", "3.1 ch", "4.1 ch", "5.1 ch (default value)",
"2.1.2 ch", or "3.1.2 ch" to suit the number of speaker channels
connected.
Subwoofer Set whether a subwoofer is connected or not.
"Yes (Default Value)": When subwoofer is connected
"No": When subwoofer is not connected
Height Speaker Set the speaker type if height speakers are connected to the
SURROUND terminals. Select from "Front High", "Top Middle
(default value)", or "Dolby Speaker (Front)" to suit the type and
layout of the connected speakers.
0 If an item cannot be selected even though connection is
correct, check that the settings in "Speaker Channels"
matches the number of connected channels.
> Install > Initial Setup > Playback
Supplementary information |
∫ Crossover
Front Set the low range capabilities for each channel by setting either
small or large.
"Small (Default Value)": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low range
capabilities
0 If "Configuration" - "Subwoofer" is set to "No", "Front" will be
fixed to "Large" and the low pitched range of the other
channels will be output from the front speakers. Refer to the
instruction manual of your speakers to make the setting.
Center Set the low range capabilities for each channel by setting either
small or large.
"Small (Default Value)": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low range
capabilities
0 When "Front" is set to "Small", this is set to "Small".
0 If an item cannot be selected even though connection is
correct, check that the settings in "Configuration" - "Speaker
Channels" matches the number of connected channels.
Height Set the low range capabilities for each channel by setting either
small or large.
"Small (default value)": For small speakers whose low range
capabilities may be limited
"Large": For full-range speakers with sufficient low range
capabilities
0 When "Front" is set to "Small", this is set to "Small".
0 If an item cannot be selected even though connection is
correct, check that the settings in "Configuration" - "Speaker
Channels" matches the number of connected channels.
Advanced Setup | Others
E
N
49