Machine-Specific Safety Warnings; Device Description; Operating Elements - SPIT P18 Manual Original

SPIT P18

Machine-specific Safety Warnings

Wear hearing protection.
The effects of noise can cause loss
of hearing capacity
Wear safety gloves.
Hold the machine with a firm grip.
High reaction torque can briefly occur while driving
in and loosening screws.
Always assume a safe standing position and
hold the power tool securely in both hands.
Use appropriate detectors to determine if utility
lines are hidden in the work area or call the
local utility company for assistance.
Contact with electric lines can lead to fire and
electric shock. Damaging a gas line can lead to
explosion. Penetrating a water line causes damage
to property or electric shock.
Hold power tool by insulated gripping surfaces,
when performing an operation where the cut-
ting accessory or fastener may contact hidden
wiring.
Cutting accessory and fasteners contacting a "live"
wire may make exposed metal parts of the power
tool "live" and could give the operator an electric
shock
Secure the workpiece.
A workpiece clamped with clamping devices or in a
vice is held more secure than by hand.
Do not work on stone containing crystalline
silica (SiO2).
This will produce dust which is dangerous to your
health.
Do not work on materials containing asbestos.
Asbestos is considered carcinogenic!
Take protective measures if there is danger of
formation of combustible or explosive dust
during operation that can be hazardous to
health.
Example: Some dusts can be carcinogenic. Wear a
dust mask and work with a dust/chip extraction
unit, if possible to connect.
Always wait until the machine has come to a
complete stop before placing it down.
The tool insert can jam and lead to loss of
control over the power tool.
Tools not in use must be locked away safely
in a dry place out of the reach of children.
Switch the power tool off immediately if the
tool insert gets jammed. Be prepared for
high torque levels if the tool kicks back.
The tool insert jams if:
 the power tool becomes overloaded or
 the tool tilts in the workpiece.
Residual risk. Although this information
sheet and the operating manuals for our
electrical tools
instructions on safe working with electrical
tools, every electrical tool involves certain
residual risks that cannot be completely
prevented through
Therefore, electrical tools must always be
operated with the necessary caution.
Check the electrical device, cable and plug
each time before using. Do not use the
electrical device when defects are detected.
Do not open the electrical device yourself
and have it repaired only by qualified
personnel using original spare parts.
Damaged electrical devices, cables and plugs
increase the risk of electric shock.

3. Device description

Read all the warnings and instructions
before using the equipment.
Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious
injury.

Operating elements

1. Rotational direction switch
2. On/Off control switch
3. Depth stop adjusting ring
English
13
contain extensive
safety mechanisms.