Power Specifications - Oki PT330 Manual De Instrucciones

11-5. Power Specifications

(1) Rated Input Voltage: 100-240V, 50-60Hz
(2) Rated Input Current:
(3) Operating Voltage:
(4) Power Consumption: During standby:
Power Connector Pin Assignment
Pin No.
1
2
3
Caution: Use the specified AC adapter for the power supply.
Caution: If our AC adapter is not used (power supply is supplied by the
1.1A
DC24V
3.0W or less/0.1A on average (Dual Interface)
4.5W or less/0.1A on average (LAN Interface)
During operation: About38W/1.5A on average
(at 24V, 25°C, print density setting 100%, paper
width 80mm, print duty 9%)
Note: Drawer Kick Drive Current: Max. 1A
However, do not operate two drawer kick at the
same time.
Signal Name
+24V
SG
N.C
user), problems such as bad print quality, electromagnetic
interference, or circuit noise may occur. In such cases, take
note of the following points:
· Use an AC adapter whose capacity corresponds to the printing
rate that will actually be used.
· Ensure in advance that there are no problems such as static
electricity, electromagnetic interference, circuit noise, etc.
±1０%
78
3
1
2