Power Save Mode - Oki C710n Guía De Referencia Rápida

Power Save Mode

Power Save sets how long the
printer waits before going into
standby mode.
Setting the Power Save
Interval
1. Press E .
NTER
2. Press the down arrow to move
down to Menus. Press E
3. Press the down arrow to move
down to System Adjust. Press
E .
NTER
4. Press E
NTER
Time.
5. Press the down or up arrow
key to highlight the value you
wish to select (5, 10. 15, 30
[default], or 60 minutes).
Press E .
NTER
6. Press O L
N INE
Disabling Power Save
The printer comes set for Power
Save enabled.
Note
A password is required to
access this area of the printer
menu. If you have a System
Administrator, only they can
disable or enable Power Save.
1. Turn OFF the printer.
NTER
to select Power Save
.
2. Turn ON the printer while
holding down the E
3. When Boot Menu appears on the
display, take your finger off the
key. Press E
4. When Enter Password appears,
enter the administrative
password (the default
password is aaaaaa).
.
a. Press the up arrow key (a to
b. Press E
c. Repeat a and b above for
5. Press E
6. Press the down arrow key to
move down to Power Setup.
7. Press E
8. Press the down arrow key to
move down to Disable. Press
E
NTER
9. Press the B
The printer will automatically
re-boot.
14
.
NTER
z, 0 to 9) or the down arrow
key (9 to 0, z to a) to scan
through the various
numbers and letters of the
alphabet.
.
NTER
each digit of the password.
.
NTER
to select Power Save.
NTER
.
key.
ACK
key.
NTER