Electrolux EKGE20C2NMS Manual De Instrucciones página 24

45 electrolux installation
Gas installation
01. This range was designed for
use with LP or NG gas . Check
the product label to verify the
gas type the manufacturer has
calibrated it with.
02. Always use a pressure
regulator exclusive for your gas
range. The lack of pressure
regulator might cause excess
of pressure and leak of gas.
Always check for the validity of
the pressure regulator. Hose
and regulator should be
replaced every 5 years.
Technical specification of the
pressure regulator:
• Pressure: 200 mm C. A.
• Max. consumption: 2 kg/h
03. Always use a PVC hose to
work from -20ºC to 100ºC. Be
sure that hose:
• does not have joins.
• does not go on the back of
the gas range neither close
to the hot air exits.
• its less than 125cm long.
04. If possible, install the gas
cylinder outside the kitchen, in
a place protected and with air
flow.
05. Use a 1/2"metallic hose to
connect to the gas range using
a L coupling connector.
06. Only use a plastic hose when
this one does not go on the
back of the gas range.
Pressure regulator
Metalic flexible tube
L coupling
connector
If you have any doubt or need to buy
any accessory for the installation,
please contact our authorize service.
Hose installation
01. Place the metal clamp on the hose end.
02. Connect the hose to the oven connector and tighten the clamp.
03. Place the other clamp on the opposite hose end and connect it to the
pressure regulator. Tighten the clamp.
04. Bolt the pressure regulator to the gas cylinder carefully.
05. After installation, check if there is any gas leak, using soap or liquid
detergent foam
Connector
installation electrolux 46
Plastic Hose