Mounting The Stove; Selecting The Installation Location; Installing The Stove - Dometic ORIGO A100 Instrucciones De Uso

_Origo_A100_A200_C100_C200.book Seite 14 Freitag, 13. Februar 2009 7:33 19

Mounting the stove

7 Mounting the stove
You can fit the stove into the countertop of your kitchen.
7.1

Selecting the installation location

When selecting the installation location, observe the following instructions:
Select a well-ventilated location for the device.
Ensure a minimum distance (fig. 6, page 4) of
– 50 mm (2") to side and back walls
– 750 mm (30") between stove coil element and horizontal surface
above the stove
Avoid draft at the installation location.
If you fit the stove in an open cockpit or other open areas mount an
additional wind protection.
Avoid cabinet storage space above the stove.
Otherwise you risk burns and fire when reaching over the stove.
Do not operate the device in spaces where danger of explosion is
present.
7.2

Installing the stove

Caution – Danger of damaging the device!
a
Before drilling any holes, make sure that no electrical cables or oth-
er parts of the vehicle can be damaged by drilling, sawing and filing.
➤ Cut a rectangular hole into the countertop (dimensions see following
table):
Model
A100
A200
C100
C200
➤ Open the top and remove the canisters.
➤ Open up the hinge part in the back of the stove.
➤ Place the stove according to fig. 4, page 3.
14
Dimensions W x D x H
255 x 150 x 340 mm
485 x 150 x 340 mm
255 x 150 x 340 mm
485 x 150 x 340 mm
Dometic ORIGO
3
10" x 6" x 13 / "
8
1 3
19 / " x 6" x 13 / "
8 8
3
10" x 6" x 13 / "
8
1 3
19 / " x 6" x 13 / "
8 8