EMKO RS Pro ESM-3711-CN Manual De Instrucciones página 14

6.5 Entering To The Programming Mode, Changing and Saving Parameter
Main Operation Screen
O O
C F
When SET button is pressed for 5
seconds, "PR" led starts to blink. If
programming mode entering
password is different from 0,
programming mode entering screen
will be observed.
O O
C
F
Password Entering Screen
Enter programming mode accessing password
with increment and decrement buttons.
Note2: If programming mode accessing password is 0, only three parameters
are accessible, and the parameter values can be changed.
Programming Screen
O O
C
F
Press SET button for accessing to the parameter
value. Press increment button for accessing to the
next parameter, press decrement button for
accessing to the previous parameter.
O O
C F
Hysteresis Value for
Compressor Output
Press set button for saving the
parameter.
If no operation is performed in programming mode for 20 seconds, device turns to main
i
operation screen automatically..
ESM-3711CN
S P
ü
Note1: If programming
mode accessing password
is 0, Temperature Unit
Selection parameter is
observed instead of
programming screen
ESM-3711CN
S P
ü
ESM-3711CN
S P
ü
ESM-3711CN
S P
ü
O
C
Programming Mode
Entering Screen
Press SET button for
accessing to the
password entering
screen.
O
C
Password Entering Screen
Press SET/OK button for
entering the password.
O
C
Hysteresis Value for
Compressor Output
Change the value with increment
and decrement buttons.
O
C
Hysteresis Parameter
for Compressor
Press increment button for accessing to the
next parameter, press decrement button for
accessing to the previous parameter
ESM-3711CN
O
S P
F
ü
ESM-3711CN
O
S P
F
ü
ESM-3711CN
O
S P
F
ü
ESM-3711CN
O
F S P
ü
14