Atlantic SOLCC2 Manual Del Producto página 2

Introduction
Thank you for purchasing Atlantic SOL Color Changing Lighting. Atlantic's SOL lighting features
solid brass bodies with an oil-rubbed bronze finish. These lights create a vibrant nighttime
atmosphere with 48 different colors and 18 different pre-programed color changing
combinations. Multiple fixtures can be connected to run through one transformer and be
controlled by one remote.
Prior to Operation and Installation
Caution:
• DO NOT operate this product under any conditions other than those for which it is
specified. Failure to observe these precautions can lead to electrical shock, product failure,
or other problems.
• Follow all aspects of electrical codes when installing SOL Lighting.
• To reduce the risk of electrical shock, connect transformer to a 120 volt receptacle protected
by a ground fault circuit interrupter (GFCI).
• Always verify that the lens cover is tightly secured before submersing the fixture
• Color Changing six wire quick-connect plugs carry both AC and DC current to the in-line
driver. Moisture entering the connections will allow the AC and DC current to cross which can
damage the lighting system.
• Six wire quick-connect plugs are gasketed for outdoor use and must be fully tightened to
prevent water infiltration. Quick-connect plugs are not waterproof and should not be
submersed. Dielectric grease (found in the electrical department of most home
improvement stores) should also be used in all connections to eliminate water infiltration.
• The input power to the Color Changing Control Module is 12 volt AC.
• The Control Module can be connected to a larger outdoor lighting transformer; however this
must be done on the 12 volt AC input side of Control Module. Removing the Control Module
or tampering with the cord between the Control Module and the light fixture will damage
the LEDs and void warranty.
• The Control Module is weather resistant with an IP54 rating. Do not submerse the Control
Module or expose it to heavy rainfall. It must be mounted off the ground close to the power
source. Failure to do so will void the warranty.
• A rectangular driver labeled *DO NOT REMOVE* is attached to the end of the light
cord by a quick-connect plug. The driver converts AC current from the transformer to DC
current before it is sent to the light.
• The driver may be temporarily disconnected at this junction when pulling the light cord
through a conduit sleeve or hardscape wall. Once the cord is pulled, the driver must be
reattached before connecting the light to a power source. Failure to reattach the driver will
damage the LED and void the warranty.
• Permanently removing the driver or cutting/shortening the cord between the driver and the
light fixture will damage the LED and void the warranty
• Extension cords (part # SOLCCEXT) are available to add an additional 20' of cord to any
SOL Light. Only one cord can be used on each light. Never connect multiple extension
cords together.
SPOTLIGHTS & LIGHT RING - SOLCC2 / SOLCC6 / SOLCCLR
Installation
SOL Spotlights offer three different mounting options for your convenience:
• Adjustable stand: for placement on rock ledges, under waterfalls or for
highlighting streambeds
2