Remote Control Functions - Atlantic SOLCC2 Manual Del Producto

Control Module
Installation
The Control Module is weather-resistant with an IP54 rating. Do not submerse it or expose it to
heavy rainfall. It must be mounted off the ground with antenna positioned vertically, close to
the power source. Failure to do so will void the warranty.
• Remove the red protective cap from the top of the control module and install the antenna.
Thread the black antenna on until snug, making sure it seals against the gasket.
• Install the control box in a well-ventilated area to ensure that the module
operates within its specified working temperature.
• Verify that the control module input voltage is 12 volt AC. We recommend that
you use the transformer provided with this unit.
• Ensure that all cable connections are secure.
• Do not connect the power before the cord connections are finished.
• Do not cut or alter the cord between the SOL Light and the Control Module.
• The remote control requires two (2) AAA batteries (not included). Do not touch the face of
the remote while inserting batteries.

Remote Control Functions

On Button
Touch and release to turn
the lights on. Touch for
A
two seconds to switch
between Color Wheel and
Preset Light Changing
Modes
B Off Button
C Color Wheel
D Indicator Light
E Brightness (Up)
Preset Light Changing Modes
Continuous full spectrum
1
fade change
2
Solid Crystal White
3
Solid Red
4
Solid Green
5
Solid Blue
6
Solid Aqua
7
Solid Purple
8
Solid Yellow
9
Red-Green-Blue jump change
F Brightness (Down)
G Speed (Up)
H Speed (Down)
Preset Light Changing
I
Mode Selection (Up)
Preset Light Changing
J Mode Selection
(Down)
10
11
12
13
14
15
16
17
18
A
C
G
E
F
H
7 color jump change
Red-Green-Blue dimmer change
7 color dimmer change
7 color dimmer then
7 color jump change
Crystal White fade on/off
Flashing Red
Flashing Green
Flashing Blue
Flashing Red and Blue
B
D
I
J
7