Atlantic SOLCC2 Manual Del Producto página 5

WIRING KITS - SOLCCMX3 / SOLCCMX7
All SOL Color Changing LED lights and wiring components are connected via a six wire
quick-connect plug. SOL Color Changing LED Lights will not operate if plugs are aligned
incorrectly. The six pronged connectors have raised arrows that indicate proper alignment.
Color Changing six wire quick-connect plugs carry both AC and DC current to the in-line driver.
Moisture entering the connections will allow the AC and DC current to cross which can
damage the lighting system.
Six wire quick-connect plugs are gasketed for outdoor use and must be fully tightened to
prevent water infiltration. Quick-connect plugs are not waterproof and should not be
submersed. Dielectric grease (found in the electrical department of most home
improvement stores) should also be used in all connections to eliminate water infiltration.
The SOLCCMX3 wiring kit enables up to three SOL Color Changing lights (any models) to be
installed together and controlled by a single transformer, control module and remote. The
transformer must be plugged into a properly grounded GFCI outlet. Please follow the
connection diagram below for proper installation.
The SOLCCMX7 wiring kit enables up to seven SOL Color Changing LED lights (any models)
to be installed together and controlled by a single Transformer, Control Module and Remote.
Please ensure that the quick-connect plugs are properly aligned and follow the connection
diagram below for proper installation.
SOLCCEXT
20' EXTENSION
CORD
SOLCCSPL3
COLOR CHANGING
CONTROL MODULE
3-WAY SPLITTER
CCCM01
TRANSFORMER
CCCM01
COLOR CHANGING
CONTROL MODULE
SOLCCSPL3
3-WAY SPLITTER
SOLTRANS88
5