Identification Of Parts; Unpacking The Heater - Master BV 80 Manual De Instrucciones

IDENTIFICATION OF
PARTS
Hot air
output
Lower
shell
Control
panel

UNPACKING THE HEATER

1 Remove all the materials used to package the heater for shipment.
2 Open the carton from the top.
2a Remove the flue connection first (BV100E, BV160E).
3 Lift up the cardboard packaging.
4 Unscrew the locking screws of the wheel-lock straps (BV80E,
BV100E, BV160E, B220CEA) or of the hub locking bar
(BV280E, B354CEA).
4a Remove the nail holding the flue connection in place (BV80E,
BV280E, B354CEA).
4b Remove the wheels from the hot air outlet (BV280E,
B354CEA).
4c Lift the heater from the air outlet end (BV280E, B354CEA).
4d Insert the wheels onto the axle (BV280E, B354CEA).
4e Insert the locking washer (which is in the documentation
envelope) with the convex side towards the exterior of the
machine; using a hammer and an appropriate-sized spanner, tap
it gently to fix it into position (BV280E, B354CEA).
5 Insert the flue connection onto the fume outlet tube (BV80E,
BV100E, BV160E, BV280E).
6 Carefully lower the heater from the platform.
7 Check the machine to make sure it has not been damaged
during transportation. If the heater appears to be damaged,
immediately contact the dealer from whom it was purchased.
Flue
connection
Upper shell
Fan guard
Fuel tank
cap
Power cable

IDENTIFICATION OF PARTS

UNPACKING THE HEATER
BV 100E, BV 160E,
B220CEA (without flue connection)
Remove the nail
Wheels
BV 80E, BV 280E
B354CEA (without flue connection)
5
Remove as soon
as the carton is
opened
Unscrew the
screws
Unscrew the screws
GB