Tabla de contenido
Publicidad
2.
Install the Legs
Screw
Vis
Lock Washer
Tornillo
Contre-écrou
Washer
Arandela de fijación
Rondelle
Arandela
Rear Leg
Pied arrière
Pata posterior
Front Leg
Pied avant
Pata frontal
NOTE: To protect the finished surface of the cabinet, perform assembly tasks on a
flat, padded work surface.
Remove the Door
Lay the cabinet on a flat, padded surface with the door facing up.
Remove the door to ease the installation process. Refer to the "Door Adjustments"
section of this guide.
Attach the Legs
Position the leg assemblies as shown; verify the clips are facing each other.
Secure each leg post using two #8 x 2" panhead screws, lock washers, and flat
washers.
Install the Cross Rail
Oriented as shown, position the cross rail above the clips between the right and
left leg assemblies.
Evenly press down on the cross rail until the clips are fully engaged. You may
need to apply slight pressure on each end until it clicks in place.
Installer les Pieds
REMARQUE: Pour protéger la surface finie de l'armoire, procéder au tâches
d'assemblage sur une surface de travail plate et matelassée.
Retirer la porte
Coucher le meuble sur une surface plate et matelassée, avec la porte tournée ver
le haut.
Kohler Co.
Cross Rail
Rail transversal
Riel transversal
Clip
Clip
Clip
5
Clip
Clip
Clip
1147374-2-D
Publicidad
Tabla de contenido
