Self-Adjust Clutch Installation Guide (Tp-1627 At Meritor.com/Lod) - Meritor TP1663 Guía De Instalación Deembrague Autoajustable

SELF-ADJUST CLUTCH
INSTALLATION GUIDE
READ CAREFULLY BEFORE INSTALLING CLUTCH
This clutch must be installed by a qualified installer. Improper installation or failure to replace
or resurface the flywheel, or to replace the pilot bearing, clutch brake or other worn drivetrain
components may cause poor clutch release or early failure and void the manufacturer's warranty.
Verify Correct Flywheel Dimensions
Flywheel bore (DIM A) must be a minimum of 10". (See Figure 1)
Figure 1
You must have a minimum of 5/16" distance from the friction surface (face) of your flywheel to the top of the bolt head that
holds the flywheel to the crankshaft. If it is less than 5/16", you need a NEW flywheel! (See Figure 3)
Flywheel clutch pilot cannot be greater than 3/16" deep. If it is greater than 3/16" the clutch will not bolt tight to flywheel.
Insert #M1001SA
STOP!
Figure 3
10"
Figure 2
(See Figure 2)
1