Reset Procedure - Meritor TP1663 Guía De Instalación Deembrague Autoajustable

RESET PROCEDURE

If for any reason the clutch needs to be reset or manually adjusted, follow the instructions below.
1. Remove self-adjusting mechanism. (Figure 7)
2. Disengage clutch.
3. Install manual adjust mechanism. (Figure 8)
4. Manually adjust clutch to meet specs in set-up procedure. (See Figure 6)
5. Reinstall self-adjusting mechanism. Ensure adjusting arm is properly seated in the retainer
stud as seen in Figure 8.
6. When reinstalling self-adjusting mechanism it may be necessary to manually ratchet the self-
adjust mechanism so that the worm gear is seated properly in the adjusting ring teeth.
Figure 7
Figure 8
INCORRECT
7
CORRECT