Stanley Bostitch P6C Serie Manual De Instrucciones

CAUTION: Read instructions carefully before operating plier, and save them for future reference.
Item No.
1 DRIVER ARM
2 CLINCHER ARM P6C
2 CLINCHER ARM P6C-8P
2 CLINCHER ARM P6C-8F
3 OPERATING LEVER
4 MAGAZINE P6C-8
4 MAGAZINE P6C-6
5 CORE P6C-8
5 CORE P6C-6
6 PUSHER
7 PUSHER SPRING
FIG. 1
TO LOAD: Pull "up" and out until magazine cover is open as far as it will go. (See FIG.1). Squeeze plier closed and
insert staple stick through loading guide, rear end first, as shown in FIG. 2. Let front end of stick drop in.
Be sure it drops in completely. Push magazine cover closed as shown in FIG. 3, until you hear a "click"
indicating that it is completely closed.
Staples Required: P6C-8 series use STCR50191/4 and 3/8
TO CLEAR A JAM: Grasp plier as if ready to staple. Insert a pencil or similar object between clincher arm and magazine,
away from staple discharge area. Operate plier once or twice to expel jammed staples. Do no pry with
screwdriver or similar tool as damage to magazine may occur.
TO DISASSEMBLE: (Assembly is reverse) Remove lever pin and operating lever. Remove loading guide by squeezing in
on sides. Remove magazine cover by disengaging front from pusher and then pulling it out. Squeeze driver
tips together with pliers until disengaged from driver arm. Swing driver arm open. Remove drive bearings.
Remove magazine spring from atop clincher arm spring. Disengage front tabs of clincher arm spring from
clincher arm and remove clincher arm spring. Push retainer rear leg out from under magazine, and lift out
assembly of core, pusher, pusher spring and retainer.
100411REVC 1/96 Litho in U.S.A.
P6C
Model
Description
P6C-6 series use STCR26191/4 and 3/8
P6C-8P series use STCR50191/4 and 3/8
P6C-8F series use STCR50191/4 and 3/8
KEEP FINGERS AWAY FROM STAPLE DISCHARGE AREA WHEN OPERATING OR WHEN
CLEARING A JAM. NOTE: P6C-8P POINTED BLADE - USE EXTRA CARE WHEN HANDLING.
DO NOT DISASSEMBLE CORE-ASSEMBLY, AS COMPRESSED PUSHER SPRING AND
RETAINER MAY FLY OFF, CAUSING EYE INJURY.
®
Series Plier
Part No. Item No.
100392 8 RETAINER
100393 9 PIVOT PIN
100396 10 DRIVER P6C-8
102482 10 DRIVER P6C-6
100394 11 CLINCHER ARM SPRING
100537 12 MAGAZINE SPRING
100540 13 DRIVE BEARING
100538 14 MAGAZINE COVER
100541 15 LEVER PIN
100399 16 E-RING
P627 17 LOADING GUIDE
FIG. 2
Description
Stanley Fastening Systems
East Greenwich, RI 02818
Part No.
100400
100401
100402
100403
100404
100405
100406
100407
100408
85018
100409
FIG. 3