Blue Clean AR 390 SS Manual Del Usuario página 11

OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
Operation Tips
• If you hear the motor run intermittently when the
trigger is not being squeezed, that is normal.
The pump is priming itself so it is ready to operate
when the trigger is squeezed. Turn off the power
washer if not being used after five minutes.
• Keep the nozzle cleaning wire for use in unclogging
the lance nozzle. If you lose the cleaning wire, a
straightened paper clip also works.
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs
because the impact force of the water pressure
exceeds the durability of the surface. Bare wood
can be penetrated; paint can be peeled off, etc.
You can vary the force of your power washer by
controlling:
1. The angle of the surface being cleaned.
2. The distance of the nozzle from the surface
being cleaned.
• NEVER use a narrow high pressure stream of
water on soft surfaces susceptible to damage.
• Use the 25˚ angle quick connect nozzle when
cleaning windows. Be sure to place the nozzle
approximately four to five feet away from the
window with the nozzle at forty five degree angle.
Squeeze the trigger and vary the spray pattern
and angle until optimum cleaning efficiency is
achieved.
92733_15ANR014 AR390SS_2000PSI ENG-FR-SP.indd 11
Using Power Cord
• Easily remove the power cord from side of unit by
swiveling the bottom blue cord hook to the right or
left until it faces up. The power cord then can be
easily slid off of the side of the power washer unit.
• Swivel blue, cord hook back down when ready to
wrap the cord back into place for storage.
Detergents
• Use detergents designed for power washers.
These can be purchased online at our website
www.arblueclean.com. Hardware stores or home
centers also have power washer detergents for
different cleaning projects. The cleaning solution
should be the consistency of water in order to
prevent clogging your detergent bottle and nozzle.
• This system applies detergent under low pressure.
The cleaning power of the detergents is enhanced
when applied with low pressure and enough
time is given to break down dirt and grime. The
combination of low pressure and chemical action
is very effective and can be better than scrubbing
if applied properly. ALWAYS spray detergent on a
dry surface. DO NOT pre-soak area. Wetting the
surface first dilutes the detergent and reduces
its cleaning ability. DO NOT allow detergent to dry
on surface. On vertical surfaces being cleaned,
apply detergent to lower surfaces and work your
way up to prevent detergent from causing streaks
in the dirt and grime. Rinse detergent by pressure
washing from bottom up for same reason.
• If a stain is particularly tough, it may be necessary
to reapply the detergent and use a bristled brush to
scrub the stain. Subsequent power washing after
brushing should successfully complete your cleaning
job.
11
2018/2/9 上午11:13