Blue Clean AR 390 SS Manual Del Usuario página 7

3
AA
Slip tab of stabilizer foot (E) into slot on bottom
righ, when facing the power washer unit (A). Secure with
screw (AA).
Hardware Used:
Screw
AA
5
To release the hose (B) from spray gun (H), turn black
collar counterclockwise. Remove gun.
92733_15ANR014 AR390SS_2000PSI ENG-FR-SP.indd 7
A
E
H
B
4
Soft PVC High Pressure Hose Assembly
Connect the other end of Soft PVC high pressure hose
(B) to spray gun (H) by screwing collar over gun inlet.
Hand tighten (turning clockwise) until tight. Hose is now
securely attached to the spray gun.
Note: Soft PVC High pressure hose (B) is fitted to the
hose reel and ready to use. It only needs to be attached
x 1
to the spray gun (H).
6
I
I
Locking Spray Gun (Before Lance Installation)
To lock the trigger of the spray gun (H), aim the gun
away from you and push the lock button from right to
left. After doing so, squeeze or pull the trigger to make
sure it is locked and will not move. Always leave lock
button in locked position when not in use. This ensures
the gun is in "safe" mode until it is ready for use.
H
B
H
Lock
H
Unlock
7
2018/2/9 上午11:13