Ordering Replacement Parts; Disposal And Recycling - EINHELL GC-LC 18 Li T Manual De Instrucciones Original

and allow the chainsaw to run. If an increasing oil
trace becomes evident during this process then
the automatic chain lubrication system is working
properly. If no clear oil trace is evident then please
refer to the corresponding instructions in "Troub-
leshooting". If the information contained there still
fails to remedy the situation then please contact
our service department or another similarly quali-
fi ed workshop.
Notice! Do not actually touch the surface with
the tip of the cutter rail when performing this test.
Keep a safe distance (approx. 20 cm).
Sharpening the saw chain
Eff ective working with the chainsaw is only pos-
sible if the saw chain is in good condition and
sharp. This also reduces the risk of kickback. The
saw chain can be re-sharpened by any dealer.
Do not attempt to sharpen the saw chain yourself
unless you have the necessary special tools and
experience.

8.3 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
Spare cutter rail: 45.001.17
Spare chain: 45.001.87
9. Storage
•
Clean the pole-mounted pruner and carry out
its maintenance before you put it into storage.
•
If you are not going to use the cordless pole-
mounted pruner for an extended period of
time, remove the chain oil from the tank.
Briefly immerse the saw chain and the cutter
bar into an oil bath and then wrap them in oil
paper.
•
Store the equipment and its accessories out
of children's reach in a dark and dry place at
above freezing temperature. The ideal sto-
rage temperature is between 5 and 30°C.
•
Use the cutter rail guard.
Anl_GC_LC_18_20_Li_T_SPK9.indb 28
GB
10. Transport
Secure the equipment during transportation in or-
der to prevent damage or injuries. Use the cutter
rail guard.

11. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 28 -
28.10.2020 08:13:20