Shark SPARTAN CARBON Manual Del Usuario página 12

TEXTILE PARTS
REPLACING THE INTERIOR PADDING
- Turn your helmet over.
- Lower the chin cover.
- Reposition the cheek pads by passing the chin
straps through the slit in the foam (Fig. A) and clip
all the studs from the two cheek pads (Fig. B).
- Start the operation by sliding the plastic tabs
of the front of the head section in its housing
beginning with one side (Fig. C).
- Reinsert the plastic tabs from the front of the
neck pad into their place (Fig. D).
- To complete the operation, unclip the front of the
head section, starting with one side (Fig. C) and
remove the head section.
- Unclip the two cheek pads (Fig. D) and slide
them along the chin straps to extract them.
WARNING! The interior padding is critical
to maintain the correct fit of the helmet
on your head. If you have any doubt whatsoever
regarding the removal or replacement of the inte-
rior padding, DO NOT USE YOUR HELMET. Contact
your retailer for assistance or advice. NEVER use
your helmet with any part of the interior padding
removed. The helmet will not protect you in an
accident.
WARNING! The polystyrene lining and inte-
rior padding are critical to properly fit your
helmet on your head. An improper fit could cause
your helmet to become dislodged in an accident,
leaving your head unprotected and resulting in
severe head injury or death. If you are not sure
that you properly replaced the comfort padding,
DO NOT USE YOUR HELMET. Contact your retailer
for assistance or advise.
12
A
B
C
D