Ferm CDM1127 Traducción Del Manual Original página 6

Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardized test given in
EN60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
• U sing the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level.
• T he times when the tool is switched off or
when it is running but not actually doing the
job, may significantly reduce the exposure
level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2- 3
Fig. A
1. Machine
2. Battery
3. Battery unlock button
4. Charger
5. Charger LED indicators
6. Chuck
7. Direction switch
8. On / off switch
9. Work light
Lithium-Ion technology
The battery provided with this machine have
Lithium-Ion technology.
One advantage of using Lithium-Ion
batteries is that, until the battery is almost
empty, hardly and power fading is
noticeable. The machine can be used
until you start noticing that the power of
the drill is elapsed. The battery is
discharged now and needs to be
charged.
6
Another advantage is that Lithium-Ion
batteries have no memory effect.
Therefore they can be charged at any
moment without degrading, independent
of the charging state of the battery.
3. OPERATING
The battery must be charged before first
use.
Removing the battery from the machine
Fig. B
• H old the machine (1) firmly with one hand
• P ush down the battery unlock button (3)
located on the side of the battery (2) with the
other hand.
• K eep pushing this button (3) down and slide
the battery forward out of the machine, like
shown in Fig. B.
Inserting the battery into the machine
Fig. B
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
• H old the machine (1) firmly with one hand
• I nsert the battery (2) into the base of the
machine as shown in Fig. B.
• P ush the battery further forward until it clicks
into place.
Charging the battery (with the charger)
Fig. C
• T ake the battery (2) from the machine
• T urn the battery (2) to upside down position
and slide it onto the charger (4) as shown in
Fig. C.
• P ush the battery until it is fully pushed into the
slot.
• P lug the charger plug into an electrical outlet
and wait for a while. The LED indicators on
the charger (5) will lighten up and show the
charger status.
LED indicators (5)
Fig.C
The charger has 2 LED indicators (5) which
indicate the status of the charging process: