Safety Instructions - Ferm TSM1032 Traducción Del Manual Original

8. Motor
9. Mains cable
10. Frame
11. Rip fence
12. Interlocking knob
13. Mitre guide
14. Nut
15. Screw

2. SAFETY INSTRUCTIONS

Explanation of symbols
Denotes risk of personal injury, loss of life or
damage to the tool in case of non­obser­
vance of the instructions in this manual.
Indicates the presence of an electrical
voltage.
Keep bystanders away.
Wear eye and ear protection.
Wear a dust mask protection.
Wear gloves when handling saw blades
and rough materials. Saw blades shall be
carried in a holder whenever practicable.
Before using the appliance
• Make sure that the saw bench is adequately
and effectively illuminated.
• When you use strip lighting you should be
aware of the so-called stroboscopic effect.
This may cause a rotating saw blade to appear
to be stationary. One solution is to use two
fittings in order to create
• phase displacement.
• Check the following points:
• Does the voltage of the motor and any fuse
employed correspond with the mains voltage?
Appliances with a voltage of 230 V~ may
be connected without problems to a mains
voltage of 220 V~.
• Are the feeder cable and plug in good condition:
sturdy, without loose bits or damage?
• Has the saw blade lost any teeth or is it
displaying cracks or fractures? If so, replace
the saw blade immediately.
• The protective hood may not be set higher
than required to let the workpiece pass.
• The riving knife should be narrower than the
saw cut and broader than the saw blade.
• Do not exercise lateral pressure on the saw
blade as it may cause it to break.
• Check the wood for knots, nails, cracks and
waste residues.
• These irregularities may cause the workpiece
to kick back dangerously.
• Ensure that no objects get into the extraction
system.
• These objects may come into contact with the
saw blades resulting in potentially hazardous
situations.
• Replace table insert when worn.
• Rebating or grooving should not be carried out.
• Saws shall not be used for slotting (stopped
groove).
• Use only saw blades for which the maximum
possible speed is not less than the maximum
spindle speed of the tool and the material to be
cut.
• When transporting the machine use only
transportation devices and do never use
guards for handling or transportation.
• During transportation the upper part of the saw
blade should be covered by the guard.
Using the appliance
• Push the workpiece that you are going to saw
securely to the table surface.
• Hold at the same time the section of the
workpiece that has been sawed to prevent it
breaking off. The hand that secures the sawed
section should remain behind the saw blade and
move away from it. Make sure that the hand that
you use to secure the workpiece does not cross
the hand that you use to operate the appliance.
• Use the push stick supplied with the appliance.
• Use the push stick to guide smaller
workpieces past the saw blade.
• Do not use long extension cables.
• Allow the appliance to cool off before moving it.
• Do not remove wood residues in the vicinity of
the saw by hand.
5