Assembly Instructions; Operation - Ferm TSM1032 Traducción Del Manual Original

Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
reel always unwind the reel completely.

3. ASSEMBLY INSTRUCTIONS

Selecting the saw blade
Select a saw blade that meets European standard
EN847. Make sure that it has the proper teeth.
In general you will be able to saw faster and less
precisely with coarse teeth than with fine teeth.
Make sure that the saw blade is sharp at all times
in order to realize an optimum result.
Do not use High Speed Steel (HSS) blades.
Changing saw blades
Fig. 2
Check before fitting the saw blade that
the mains plug has been removed from
the electrical socket.
To change the saw blade proceed as follows:
• Loosen the two screws (A) from the sawdust
collection bin (B).
• Remove the sawdust collection bin.
• Loosen the nut (C) from the saw blade with a
spanner.
• Secure the spindle with a second spanner.
• Remove the flange (D).
• Remove the saw blade, moving it diagonally
downwards.
• Check that the flange (E) behind the saw blade
is in its correct position before fitting a new
saw blade.
• Fit a new saw blade and carry out the
foregoing procedure in reverse sequence.
Check when fitting the saw blade that the
arrow on the saw blade is pointing in the
same direction as the arrow on the
sawdust collection bin.
Placing/adjustment of the upper saw blade guard
Fig. 1
Place the upper saw blade guard:
• Remove lock bolt 14 and nut 15 from the
upper saw blade guard (2).
. When using a cable
2
• Place the recess of the upper saw blade guard
over the riving knife (5).
• Secure the upper saw blade guard (2) with lock
bolt and nut (14 and 15).
• Attention: the upper saw blade guard must be
able to move freely.
Adjusting the riving knive
Fig. 3
Sawing will reduce the diameter of the saw blade.
The space between saw blade and riving knife
must however remain more or less constant. This
means that you will have to re-adjust the riving
knife from time to time.
To adjust the riving knife you should proceed as
follows:
• Remove the inset piece (A) by loosening the
screws (B).
• Loosen the screws (C) of the riving knife.
• Adjust the riving knife (D) so that the
separation between the upper edge of the
knife and the saw blade is at least 3 mm and at
most 5 mm.
• Re-adjust the riving knife whenever the
separation exceeds 5 mm.
• Re-tighten the screws (C).
• Refit the inset piece (A).
Adjusting angle of saw cut
Fig. 4
It is possible with the saw bench to saw at various
angles, to a maximum of 45°.
The saw-cut angle is set as follows:
• Loosen the knobs (A). These are located
opposite one another on the sides of the saw
bench.
• Adjust the saw blade to the angle required. The
saw angle is displayed on the protractor (B).
• Tighten the knobs (A) once more securely.

4. OPERATION

When you depress the red off switch the saw
bench will switch off. Depressing the green on
switch will activate the saw bench. Should the
mains power fail or when the plug is removed from
the electrical socket, the safety switch will switch
the appliance off immediately. The appliance
will not activate automatically when the power is
7