Indicator Panel (Model-Dependent, Optional) - MTD ALPHA95-165H Manual De Instrucciones

EN
With the differential lock activated, power is
transmitted to both rear wheels. The differential lock
intervenes if different wheel speeds are detected.
Stop the device.
Î
To activate the differential lock, step on the
Î
pedal M.
To deactivate the differential lock, take your foot
Î
back off the pedal M.
Note
If the differential lock does not release im-
mediately, reduce the speed of the device or
bring the device to a standstill.
Parking the device
Stop the device.
Î
Switch off the cutting mechanism.
Î
Set the throttle to the centre position.
Î
Bring the cutting mechanism into the highest posi-
Î
tion.
Switch the motor off after 20 seconds.
Î
Engage the parking brake.
Î
Remove the ignition key.
Î
Pushing the device
Note
The gear release lever is located between
the rear panel and the device's right rear
wheel.
Devices with differential lock Ka
Switch the motor off.
Î
Disengage the parking brake.
Î
Pull the gear release lever out fully.
Î
3 You can now push the device.
Note
Before you start the motor, press the gear
release lever back in fully.
Devices without differential lock Kb
Switch the motor off.
Î
Disengage the parking brake.
Î
Press the gear release lever in fully.
Î
3 You can now push the device.
Note
Before starting the motor, pull the gear
release lever out again fully.
20

Indicator panel (model-dependent, optional)

12-volt socket (model-dependent) X
The socket is used for connection of a 12 volt
battery charger or connection of miscellaneous 12
volt devices.
Note
Observe the corresponding information of
the battery charger or the 12 volt devices
that are to be connected.
Indicator panel (model-dependent,
optional)
Note
The indicators only come on when the motor
is running.
Note
If an oil change and air filter maintenance
arise simultaneously, the oil change indicator
lights up first, then the air filter indicator.
Depending on the design, the indicator panel may
consist of the following elements:
Type 1 Oa in conjunction with the ignition
lock Ha
Operating hours counter
When the ignition is activated, the battery voltage is
briefly displayed. This then changes to the operating
hours indicator.
The operating hours are always counted, except
when the ignition key is at "Stop" or is withdrawn.
Maintenance indicator
Note
means: The total operating hours are
displayed.
– –
Change the motor oil immediately (see the oper-
Î
ating instructions for the motor).
This indicator appears every 50 operating hours for
a period of 2 hours.
Oil change
–