HSM Classic 412.2 Instrucciones De Servicio página 12

Risk of injury from slivers!
Splinter protection from the cross cut ma-
chines is only guaranteed if the safety ele-
ment is covering the paper feed opening.
Feed hard credit cards, CDs, discs or DAT
cassettes only into the insertion slot.
WARNING
Dangerous mains voltage!
Improper handling of the machine
can lead to an electric shock.
– Before you insert the power plug, make
sure that the voltage and frequency of
your power supply comply with the infor-
mation on the name plate.
– Make sure that the power plug is easily
accessible.
– Make sure that no water gets into the
shredder. Do not immerse the power ca-
ble or the power plug in water.
– Never touch the power plug with wet
hands.
– Never pull the plug out of the socket us-
ing the power cable. Always pull out the
plug directly.
– Only use the machine in a dry room in-
doors. Never operate the machine in
damp rooms or in the rain.
Check the machine and cable
regularly for damage. Switch the
shredder off if it is damaged or
not working correctly or before
relocating or cleaning it and dis-
connect it from the mains.
– Keep the machine, the plug and cable
away from open fi re and hot surfaces.
The ventilation slots must not be blocked
or covered and there must be at least
5 cm space between the shredder and
any wall or furniture.
12
Service work which requires the
housing covers to be removed
may only be carried out by HSM
Customer Service and service
technicians of our contractual
partners.
See page 92 for our customer service
addresses.
Notice Danger from improper use
Only operate this machine in accordance
with the instructions outlined in "Proper
use".
Only US-version:
Screw the document shredder to the wall
tightly for better stability. The fastening kit
supplied is only suitable for fi tting to a stone
or concrete wall.
• Screw the brackets in (short side to the
document shredder) on the left and right,
on the back of the machine. The holes
have already been made on the back.
• Place the document shredder in the in-
tended location and make a mark for the
holes on the wall.
• Drill the holes for the plugs, insert the
plugs and then screw in the document
shredder tightly with the screws supplied.
Classic 412.2
english english
06/2014