Replacing The Bulbs - Thermador 9000411578 Manual Del Usuario

REPLACING THE BULBS

CAUTION. Avoid risk of electric shock
by switching off the hood and pull out the
power plug or switch off the electricity
CAUTION. Avoid risk of burns.
Halogen bulbs become very hot and remain
hot for some time after being switched off.
1. Remove the bulb ring with a screwdriver
or similar tool.
12
2. Replace the halogen light bulb
(conventional halogen bulb, 12 Volt,
max. 20 Watt, G4 bulbholder).
IMPORTANT: Plug-in bulbholder.
Take hold of the bulb with a clean cloth.
Finger prints can shorten bulb life.
3. Re-insert the bulb ring.
4. Restore the power by inserting the mains
plug or switching on the fuse.
Note: If the light does not function, check
that the bulbs have been inserted correctly.