Deleting Transmitters From The Memory; Deleting Memorised Data - Nice Free-Max Instrucciones Y Advertencias Para La Instalación Y El Uso

03. Press and hold down key ▲ (if Automatic or
(5")
Manual programming were made at the begin-
5
ning), or key ▼ (if Semiautomatic programming
was made), for approx. 5 seconds, until the
motor performs 5 LONG motions (= positions
"0" and "1" cleared), then release the key.
Note – In order to move the roller shutter/awning after the positions have been
cleared, the transmitter key must be pressed and held down for the time nec-
essary to complete the desired manoeuvre (hold-to-run mode).
DELETING TRANSMITTERS FROM
11
THE MEMORY
✔
For AWNINGS: For ROLLER SHUTTERS:
Caution! – This procedure deletes all memorised transmitter codes from
Free-Max memory. The procedure can be performed both with a memo-
rised transmitter as well as a non memorised transmitter.
If the transmitter is memorised, proceed as follows:
01. Press and hold down key ■ (for approx. 5 sec-
(5")
onds), until the motor performs 1 VIBRATION;
1
then release the key.
02. Press and hold down key ▲ until the motor per-
forms 3 LONG motions; then release the key
3
exactly on the third movement.
03. Press and hold down key ■ until the motor per-
forms 3 LONG motions; then release the key
3
exactly on the third movement.
04. Press and hold down key ▼ until the motor per-
forms 3 LONG motions; then release the key
3
exactly on the third movement.
After a few seconds the motor performs 5
LONG motions (= all transmitters deleted).
5
16 – English
If the Transmitter is not memorised, proceed as follows:
off on
(5"...)
on
✔
12
For AWNINGS:
Caution! – The following procedure deletes all the data contained in
Free-Max Memory, including positions "0", "1", the optional functions
present and all memorised transmitter codes.
The procedure can be performed both with a memorised transmitter as
well as a non memorised transmitter.
If the transmitter is memorised, proceed as follows:
(5")
A. Disconnect from power supply (if connected)
(5")
and connect again the tubular motor to the
1
power supply. Within the next 60 seconds,
press and hold down key ■ (for approx. 5 sec-
onds), until the motor performs 1 VIBRATION;
then release the key.
B. (within the next 5 seconds) Disconnect from the
power supply.
off
C. Power the motor again: the previous proce-
01.
dure, from point 01 to point 04, must be per-
02.
(60"...)
formed within 60 seconds from turning on the
....
power supply.
DELETING MEMORISED
DATA
✔
For ROLLER SHUTTERS:
01. Press and hold down key ■ (for approx. 5 sec-
onds), until the motor performs 1 VIBRATION;
1
then release the key.
02. Press and hold down key ▲ until the motor per-
forms 3 LONG motions; then release the key
3
exactly on the third movement.
✔