Assembly; Functions - Sage BCP600 Guía Rápida

Assembly

ASSEMBLING THE JUICER
1. Pull the juice press arm up, away from the
motor base, until fully extended.
2. Place the juice collector onto the drive shaft on
top of the motor base, ensuring the juice spout
fits into the semi-circular groove at the front
of the motor base.
3. Insert the filter into the juice collector, aligning
the indent with arrow in the bottom of the filter
over the corresponding tab with arrow in the
juice collector.
4. Place the juicing cone onto the drive shaft and
press down lightly to lock the cone into position.
5. To insert the fruit dome, place it into the hole on
the underside of the juice press arm. The fruit
dome is magnetic and will stick into place.
6. Ensure the anti-drip juice spout is pushed
down into the pouring position.
DISASSEMBLING THE JUICER
1. Turn the juicer OFF at the ON/OFF button,
then unplug from the power outlet.
2. Pull the juice press arm up, away from
the motor base, until fully extended.
Close the anti drip spout by flipping it up.
3. Remove the fruit dome by pulling on it gently
to release the magnet
4. Lift the juice collector from the base with the
filter, juicing cone and fruit dome still in place.
Remove the cone and filter from the juice
collector over a sink for easier cleaning. Follow
recommended care and cleaning guidelines.
6

Functions

1. Ensure the juicer is correctly assembled and
a glass or jug is placed under the juice spout
before juicing.
2. Cut the citrus fruit in half by cutting across the
fruit segments, rather than across the tip ends,
to ensure more efficient juicing.
3. Plug the power cord into a 220–240V power
outlet, then press ON/OFF switch to ON.
4. Place a citrus fruit half, cut side down,
onto the juice cone and push down lightly
onto the spikes.
5. Grasp the handle and slowly lower the juice
press arm. Press down (in a gentle but firm
action) until the fruit dome is in contact with the
fruit skin. The motor will automatically start and
the juicing cone will begin to rotate. The juice
will be extracted from the fruit and flow through
the juice spout into the glass. The pulp and
seeds will collect in the filter.
6. The juicer juices very quickly so each
fruit half will be juiced in a few seconds.
To automatically stop the motor, lift the juice
press arm up to its extended position.
7. Remove the used fruit from the
juicing cone. Empty excess pulp
and seeds from the filter as required.
Repeat Steps 3–7 to continue juicing.
NOTE
The filter should be emptied when full with pulp
and seeds. The filter can be emptied during juicing
by turning the juicer OFF at the ON/OFF switch
and carefully removing the juicing cone and filter.
Clean and replace filter and juicing cone before
continuing to juice. Do not allow the filter to overfill
as this may prevent correct operation or damage
the unit.