Electrical Safety - Grizzly ELS 3017 E Manual De Instrucciones

CAUTION! The following states how
damage to the trimmer and possible
injury to people can be avoided:
• Do not stretch the body too far and en-
sure that balance is maintained.
• Handle the unit with care. Clean the
ventilation slits regularly; keep to the
maintenance instructions.
• Do not overload your device. Work
only within the indicated range of
performance. Do not employ any low
power machines for heavy work. Do
not use your device for purposes for
which it has not been designed.
• Do not attempt to repair the appliance
yourself unless you have specific train-
ing to do so. Leave any work not listed
in this manual to our Service Centre.
• Check the grass bag regularly for wear
or damage.

Electrical safety:

CAUTION! The following states how
to avoid accidents and injuries due
to electric shock:
• Make sure that the mains voltage is
compatible with the information of the
label.
• Connect the device, as far as possible,
only to a plug socket with a ground-
fault circuit interrupter (g.f.c.i switch),
with a rated residual current at not
more than 30 mA.
• Check the device and the power cable
with plug for damage before every use.
Avoid bodily contact with grounded
parts (e.g. metal fences, metal post).
• The coupling of the extension cord must
be protected against splashed water, it
must consist of rubber or be surrounded
by rubber. Employ only extension cords
which are stipulated for use in the
open air and are marked accordingly.
The flexible lead cross-section of the
extension cord must at least 2.5 mm
Always roll out the cable drum com-
pletely before use. Check the cable for
damage.
• Keep the cable away from the field of
action and basically play it out behind
the operator.
• Use the tension relief provided for the
fixing of the extension cord.
• Do not carry the device by the cable.
Do not use the cable to pull out the
plug from the plug socket. Protect the
cable against heat, oil and sharp
edges.
• Damaged cables, coupling and plugs
or connecting leads not correspond-
ing to specifications, must not be em-
ployed. Remove the plug immediately
from the plug socket in case of damage
to the mains cable.
Do not touch the mains power supply
cable under any circumstances until
you have pulled the plug out of the
mains socket.
• If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualified per-
son in order to prevent hazards.
• Do not use the appliance if the on/off
switch does not work properly. Always
have a damaged switch repaired by
our Service Centre.
• Before each use, check the power sup-
ply lead and the extension cable for
damage and ageing. Do not use the
equipment if the cable is damaged or
worn.
GB
.
2
139