Assembly Instructions - Grizzly ELS 3017 E Manual De Instrucciones

GB

Assembly instructions

Remove the power plug be-
fore all work on the device.
Employ only original parts.
Danger of injury.
Unpacking:
Unpack the device and check whether it is
complete:
5 Foliage vacuum motor part
A
2 Two-part blower/vacuum tube
18 Collection bag with bag holder
nozzle
20 Guide rollers
22 Flat nozzle
1 Carrying strap
3 + 4 Assembly material
Translation of the original instruc-
tions for use
Before putting the device into op-
eration, the blower / suction tube
must be completely mounted and
screwed tight and the collection
bag and carrying strap must be at-
tached. The impeller wheel cover
must be closed and the attachment
screws must be tightened all the
way.
Mounting of blower / suction tube:
Make sure the tubes are held
straight during mounting.
1. Connect the two parts of the
B
blower / suction tube (2a + 2b).
2. Fasten down the tube sections us-
ing the smaller enclosed screws
(3).
3. Insert the blower / suction tube
140
into the blower / suction opening
on the motor component (5). Use
the guide rail on the motor com-
ponent as an aid.
4. Fasten down the tube and motor
component using the larger en-
closed bolts and nuts (4).
Mount flat suction nozzle:
5. To work with the flat suction nozzle
(22), push it onto the suction opening
(23) on the tube until the lateral clips
engage.
To remove the nozzle, pull the clips on
the nozzle apart and pull the nozzle
out of the tube.
Mount collection bag:
6. Place the retainer frame (17) onto the
opening on the motor components
(5) so that the grip points towards the
mains cable. Press the retainer frame
over the engagement strip until the cou-
pling lever engages.
Suction operation is only permissible
with the collection bag mounted.
7. Connect the collection bag retainer
loop (19) to the blower / suction tube.
Mount carrying strap:
8. Hook the carrying strap (1) onto the at-
tachment bar (8).