Wolf ICBDD30 Guia De Instalacion página 3

SPECIFICATIONS
Installation Requirements
This product is only suitable for installations with other Wolf
products.
For installation with a Wolf cooktop, a minimum 638 mm
deep flat countertop is required.
For installation with a sealed burner rangetop, an accessory
trim kit is required. Contact your authorized Wolf dealer for
details.
The remote-mounted control module can be positioned
horizontally or vertically. It must be located within 3 m of the
downdraft assembly and a minimum 76 mm from the edge
of the cooktop or rangetop cut-out.
BLOWERS
CAUTION
For use with Wolf 1014 m 3 /hr internal blower and
remote blowers rated maximum 3 amps.
Internal and remote blower assemblies are available through
your authorized Wolf dealer.
Internal blowers include a 152 mm round discharge, can
be front or rear mounted and can be discharged in any
direction by rotating the blower box. Remote blowers have
a 254 mm round discharge and can be discharged from the
front or rear.
DUCTWORK
Wolf downdrafts must be vented outside.
Consult a qualified HVAC professional for specific
installation and ducting applications.
The downdraft will operate most efficiently with the fewest
number of elbows and transitions and when ductwork does
not exceed 12 m.
Electrical
Installation must comply with all applicable electrical codes
and be properly grounded (earthed).
Locate the electrical supply as shown in the illustrations on
pages 3–4. A separate circuit, servicing only this appliance
is required. A ground fault circuit interrupter (GFCI) is not
recommended and may cause interruption of operation.
Certain installations may require that the electrical supply
be placed in an adjacent cabinet.
ELECTRICAL REQUIREMENTS
Electrical Supply 220-240 V AC, 50 Hz
220 V AC, 60 Hz
Service 10 amp dedicated circuit
Receptacle grounding-type (earthed)
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an elec-
trical short circuit, grounding reduces the risk of electric
shock by providing an escape wire for the electric current.
This appliance is equipped with a cord having a grounding
wire with a grounding plug. The plug must be plugged into
an outlet that is properly installed and grounded.
WARNING
Improper grounding can result in a risk of electric
shock. Consult a qualified electrician if the grounding
instructions are not completely understood, or if
doubt exists as to whether the appliance is properly
grounded.
Do not use an extension cord. If the power supply cord
is too short, have a qualified electrician install an outlet
near the appliance.
Downdraft
INSTALLATION WITH COOKTOP
68 mm
210 540
mm* mm
SIDE VIEW
*152 mm back from countertop cut-out when internal blower is rear mounted.
NOTE: Internal blower 152 mm round, side, rear or bottom discharge. Remote blower 254 mm round, rear discharge.
Centerline indicates center of downdraft cut-out.
CUT-OUT WIDTH
ICBDD30
ICBDD36
ICBDD45 1003 mm
W
DOWNDRAFT
CUT-OUT WIDTH
E
210 mm*
COOKTOP CUT-OUT
TOP VIEW
540 mm 594 mm
E
FRONT VIEW
W
699 mm
851 mm
wolfappliance.com | 3